The Most Important Thing about Installing Hardware

As I face the prospect of disassembling my trimaran, I am reminded about the most important thing to do with installing any hardware with epoxy. And I hope to find out that I kept this in mind when I built Geko. MOLD RELEASE
Every fastener set into epoxy should have already had mold release was rubbed into it and buffed. Or even green soap. New builders don’t believe it, but much of your hardware will move or be replaced over the years. And I will admit perfidy on this. The evidence is when is forced to use the battery and jumper cables to heat the fastener. Mold release!

Leave a Reply

Your email address will not be published. Required fields are marked *